Quality Belvedere Park GA septic system installers do a lot of legwork, long before a unit gets installed into the ground. A new unit will last many years, and possibly even generations, if it’s set up properly, but it can break down instantly if it’s not. On top of that, all Belvedere Park GA septic system installers must obtain a permit in order to carry out the install, and may ought to partner with city or county officials to show that a number of tests were performed in order to proceed. These three tests are necessary first steps that should always be taken before any job or designs are done, and it may also be advantageous to do them before you acquire a property, so you could be assured that a tank and leach field will be allowed.
1. Pit
The pit test is pretty uncomplicated. During the course of this test, a hole is dug and the soil is analyzed to determine its composition. A typical leach field is dependent on the soil’s structure to drain efficiently. If there is a bunch of gravel or sand, your leach field should be able to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a bunch of clay or rock, it won’t drain well, therefore a conventional leach field will not be an alternative. If the site you’ve selected does not pass the pit test, you may be able to choose another site on your property or use an alternate type of drain field, like a mound system.
2. Perc
The perc, or percolation test, consists of digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is commonly left drenched for about two hours, and topped off as needed. After this, the hole is filled with 6 inches of water and observed for water drainage.
3. Visual
There are a variety of things an inspector will check visually. The majority of units are gravity-fed, so they don’t depend on electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the incline of the ground is very important. An inspector will also seek out slopes that could feed excess water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality Belvedere Park GA Septic System Installers Now
Choosing the right layout, kind of system, and evaluating the land effectively, are all important steps in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done correctly, so that a system provides many years of use without issue. If you’re prepping for an install, call Septic Tank Pros Covington GA. Our partner specialists are skilled and dedicated to quality, so you can be sure the job is done right. Call (678) 212-5257 right now.